Most launderingproblems are easily and washer problems. If you need
solved if you understand the cause, further assistance, see page 66.
Check these tables for common laundry
Problem Possible Cause Solution
Washer Leaks Household plumbing is leaking. Repair plumbing.
Inlet hoses not tight. Tighten hoses
(see "INSTALLATION','Sections E & F).
Inlet hose washers not Reseat washers
properly seated. (see "INSTALLATION','Section E).
Drain hose not properly Clamp drain hose
clamped or is off. (see "INSTALLATION','Section D).
Drain is clogged. Remove drain clogs. Laundry tub,
standpipe, or floor drain must be able to
handle 17 gallons of water per minute.
Tub moved forward during Ensure tub is centered before
unloading, causing water starting washer.
to deflect off of tub ring.
Laundry center not level
causing water to deflect off
of tub ring.
Ensure front feet are installed and
nuts are tightened. Level laundry
center. Reset rear legs
(see "INSTALLATION','Section H).
Load is unbalanced. Spray Redistribute the load.
rinses are deflecting off of load.
Washer is:overloaded. Fills Reduce load size.
or spray rinses are deflecting
off of load.
Won't Drain/ Drain hose is kinked Straighten or unplug hose
Won't Spin/ or clogged. (see "INSTALLATION','Section D).
Wet Loads
Correct operation of After a wash or rinse, the washer will
neutral drain, drain without spinning. After draining,
the spinning begins.
Lid is open. Close the lid.
Drain hose is more than Lower drain hose
96 inches above floor. (see "INSTALLATION','Section D).
Too much detergent- Use less detergent.
excessive sudsing.
Wrong cycle for load Choose a cycle with a higher spin
.. being washed, speed (see "OPERATION").
59
