SUSPENSION 11 -21
Tie-rod, Rocker Arm
Tie-rod Removal
•
Using the jack under the frame, raise the rear wheel off
the ground.
Special Tool - Jack: 57001-1238
•
Remove the tie-rod front mounting bolt [A].
CAUTION
When pulling out the mounting bolts, lift the rear
wheel slightly. Forcing or tapping on a bolt could
damage the bolt, sleeve, and bearing.
•
Remove the tie-rod rear mounting bolt [B], and then take
out the tie-rods [C].
Tie-rod Installation
•
Apply plenty of grease to the inside of the needle bearings
and oil seals.
•
Tighten the tie-rod front and rear mounting nuts.
Torque - Tie-rod Mounting Nuts: 59 N·m (6.0 kgf·m, 43 ft·lb)
Rocker Arm Removal
•
Using the jack under the frame, raise the rear wheel off
the ground.
Special Tool - Jack: 57001-1238
•
Remove the chain [A] and the l ower chain guide roller [B].
•
Remove the tie-rod front mounting bolt [A].
CAUTION
When pulling out the mounting bolts, lift the rear
wheel slightly. Forcing or tapping on bolt could
damage the bolt, sleeve, and bearing.
•
Remove the rear shock absorber lower mounting bolt [B].
•
Remove the rocker arm pivot shaft [C].
•
Remove the rocker arm [D].
