Invacare 1073955 Manual

A SERVICE OF

next previous

SECTION 6—ARMS

Part No. 1073955 47 Orbit

™

4. Re‐securethesideguardtothebottomclampwiththetwobottommountingscrews.

Securelytighten.

5. InstalltheT‐armontothewheelchair.RefertoInstalling/RemovingtheT‐armson

page 42.

FIGURE 6.7 Adjusting the Transfer Assists and/or Side Guards

Replacing the T-Arm Locking Lever

NOTE:Forthisprocedure,refertoFIGURE 6.8onpage48.

1. Remove theT‐armfromthewheelchair.RefertoInstalling/RemovingtheT‐armson

page 42.

2. Remove thephillipsboltandlocknutthatsecuretheexistinglockinglevertothe

bottombracket.

NOTE:Thelockingleverisspringloaded.Placeyourfreehandoverthelockinglevertoprevent

thepartsfromspringingoffofthebottombracket.

3. Remove theexistinglockingleverandspringfrom

thebottombracket.

NOTE:Inspectthespringforwearanddamage.Replaceifnecessary.

4. PositionthespringonthebottombracketasshowninFIGURE 6.8.

5. Positionthenewlockingleverontothespringandthebottombracket.

NOTE:Makesurethetwoextendedendsofthespringareinsidethenotchin

thelockinglever.

6. Lineupthemountingholesinthenewlockinglever,springandbottombracket.

Bottom Mounting

Screws (STEPS 2,4)

Bottom Clamp (STEPS 2,4)

Transfer

Assist

Side

Guard

T-Arm