Page 17 of 19 2478D - Rev: 1/21/2014 7:32 AM
Available in White, Ivory, Almond
UV Stabilized Polycarbonate
Beeper Yes
Operating Temperature Range
0 - 104 degrees Fahrenheit (-18 – 40 degrees Celsius)
0-90% relative humidity, non-condensing
4F to +158F (-20 – 70 degrees Celsius)
50-60Hz (+/- 5%) Auto Detect
Retains all settings without power
Yes, all saved in Non-volatile EEPROM
Standby power consumption
ETL (Intertek Testing Services)
Troubleshooting
LED won’t come On SwitchLinc not getting power
Make sure circuit breaker is on
Check the junction box wires to ensure all
connections are tight and no bare wires are
Check that a standard incandescent bulb is
installed and is rated for 30-watts
SwitchLinc won’t Add
to Scene as a
Responder
The Controller may have dropped
out of Add to a Scene mode, or
Try Adding SwitchLinc to the Controller
again
The INSTEON signal may not be
getting to the “vicinity” of
Make sure phases are bridged, add
additional INSTEON devices and/or move
around existing INSTEON devices
Controller is a powerline only
device (SwitchLinc 2-Wire is RF
You'll need to add a Dual-Band INSTEON
device to bridge between powerline only
