IRLinc Receiver Owner’s Manual
Page 8 of 13
Multi-Unlinking
Multi-Unlinking Mode can be used to quickly remove devices from an INSTEON scene. You may remove
as many of the Linked Responders from the scene as you would like.
The following will work for the most common INSTEON devices:
1) Set the Controller to Unlinking Mode. (For most Controllers, press & hold the desired On or Scene
button for 10 seconds twice or the Set button for 3 seconds twice.)
2) Tap the Set button on the Controller. If the Controller does not have a Set button, tap the same On or
Scene button you used to put the Controller into Unlinking Mode.
Multi-Unlinking Mode will automatically time out after 4 minutes of inactivity.
3) For each of the Responders you wish to Unlink, press & hold the Set button for 3 seconds. (If the
Responder is a multi-scene device, tap the Scene button you wish to Unlink and then press & hold
the Set button.)
4) After you have Unlinked the desired Responders, tap the Controller’s Set button to exit Multi-
Unlinking Mode. If the Controller does not have a Set button, tap the same On or Scene button you
used to put the Controller into Unlinking Mode.
5) Test that you have removed the desired Responders from the INSTEON scene by tapping the button
you just Unlinked from on the Controller
Restoring Power to IRLinc Receiver
IRLinc stores all of its settings, such as Links to other INSTEON devices, with non-volatile memory.
Because settings are saved in this non-volatile memory, they will not be lost in the event of a power
failure.
Resetting IRLinc Receiver to its Factory Default Settings
The factory reset procedure will clear IRLinc of all INSTEON Links and any programmed X10 addresses.
1) If you are using IRLinc to control any INSTEON devices, Unlink those devices from IRLinc. See
Unlinking an INSTEON Responder from IRLinc.
2) Unplug IRLinc for 10 seconds
3) While holding down the Set button on IRLinc, plug it back in, making sure not to let go of the Set
button
4) Continue to hold down the Set button for 3 seconds and then release
About 20 seconds after releasing the Set button, the blue IRLinc Status LED
will flash twice
NOTE: The blue IRLinc Status LED may or may not be on during reset.
