INFINITY CLASSIA PSW310W (120V)
SYSTEM CONNECTIONS
Choose either Wireless or Wired connection,then follow the appropriate instructions.
WIRELESS
If your receiver/processor does not contain a Dolby Digital
or DTS processor but has subwoofer outputs:
Connecting the Subwoofer for Wired Applications
If you have a Dolby
®
Digital or DTS
®
receiver/processor with
a low-frequency effects (LFE) or subwoofer output:
NOTE: If your receiver/processor has only one sub out, you
may use either the L or R input.
WIRED
Connecting the Subwoofer for Wireless Applications
Step 1.
Connect a subwoofer cable from the subwoofer or LFE output of
your receiver to the Sub In
H
on the transmitter.
Step 2.
Plug the transmitter module into the wall outlet, and connect the
included power supply and power cord to the transmitter
F
. Make
sure the Transmitter Antenna
E
is extended upward.
Step 3.
Set the ID code on the transmitter and subwoofer
(
G
and
§
) to
the same position, as described on page 4.When connected properly,
the LED
¢
on the rear of the subwoofer will be orange.
Step 4.
Set the Low-Pass Selector
∞
to the “Off”position.
NOTE: Some receivers have two subwoofer outputs. In that case, use
either one of the connectors.
