UNDERSTANDING POWER RATINGS
An A/V (audio/video) receiver with limited power output can
actually cause damage to your speakers. When played beyond
its power capability, it will go into clipping. This generates
spurious high-frequency signals which, when routed to the
tweeter, can cause it to overheat and fail.
3
WIRING THE SYSTEM
After placing the Outrigger speakers, you are ready to wire them.
First turn off all audio system power. Use high-quality speaker wire
(#16 gauge or heavier) to make your connections. Use weather-
proof wire for outdoor installations. Consult the owner’s manuals
that were included with your amplifier or receiver to confirm
connection procedures.
Strip the ends of the speaker wires about
3
⁄8". Twist the wire
strands together for terminal insertion. Observe polarities when
making speaker connections, as shown in Figure 4. Outrigger
speakers have screw-down terminals for easy wiring. Open the
terminal shell by turning it counterclockwise to expose the
FIGURE 4. An example of how to connect Outrigger speakers to
a stereo receiver.
opening in the post. Insert a wire from each + terminal on the
back of the amplifier or receiver to the respective + (red)
terminal on each Outrigger speaker.Turn the terminal shell
clockwise until it secures the connection. Similarly, connect the
– (black) terminal in the same way.
If desired, you can use banana plugs (available at your local elec-
tronics store) to make these connections.
IMPORTANT! Do not reverse polarities (i.e., + to – or – to +)
when making connections. Doing so will cause poor
imaging and diminished bass response.
Overdriving the power amplifier must be avoided. It is always a
good idea to choose a receiver with more power than you need.
(Refer to power ratings in Specifications on the next page.)
