IBM T54A Manual

A SERVICE OF

next previous

12

Manual Setup

Normall

y

,

y

ou can complete the setup procedure usin

g

A

UTO

S

ETUP

, however,

if

y

our screen ima

g

e is still distorted after

y

ou perform

A

UTO

S

ETUP

or the

setup diskette does not run on

y

our s

y

stem, perform

M

ANUAL

S

ETUP

.

If the monitor is in standb

y

mode (STANDBY ON), it

mi

g

ht automaticall

y

turn off

while

y

ou are waitin

g

for it to

warm up.

1. Have

y

our monitor turned on for about 15 minutes, until the monitor

warms up.

2. Displa

y

the ima

g

e

y

ou most frequentl

y

use on the screen.

3. Press the OSD Enter button at the bottom of the monitor to displa

y

the initial OSD menu.

4. Use an Arrow button ( or ) to select the IMAGE LOCK icon

and press the OSD Enter button to access the function.

5. Usin

g

an Arrow button ( or ), select

MANUAL

, press and then

press once to select

COARSE

. Left and ri

g

ht arrow adjustment

indicators become illuminated (see pa

g

e16

).

6. Use the Arrow buttons to manuall

y

adjust to correct (as much as

possible) for noise in the video si

g

nal then press to save the

chan

g

es.

7. Use an Arrow button to select

FINE

and press the button.

8. Use the Arrow buttons a

g

ain to tune the ima

g

e to

y

our likin

g

.

9. When finished, press the Exit button four times to exit from the

OSD.

You have completed the monitor setup.

T54A-E.book Page 12 Saturday, February 19, 2000 12:05 PM