Table 18. Removal steps of wireless USB adapter or Intel Turbo Memory
Note: Step1is only for models with the wireless USB adapter. For models with the Intel Turbo Memory Minicard,
skip step
1.
In step
1, unplug the jack by using the removal tool antenna RF connector (P/N: 08K7159) or pick the connector
with your ngers and gently unplug them in direction of the arrow.
When installing: In models with the wireless USB adapter, route the antenna cable as shown in this gure and plug
the cable rmly into the jack on the adapter.
Step Screw (quantity) Color
Torque
2
M2 × 6 mm, at-head, nylon-coated (2) Silver
0.181 Nm
(1.85 kgfcm)
1100 Palm rest or palm rest with ngerprint reader
For access, remove these FRUs in order:
• “1010 Battery pack” on page 75
• “1030 Solid state drive (SSD) or hard disk drive (HDD)” on page 76
Chapter 8. Removing and replacing a FRU 91
