15
DEUTSCH
ENGLISHFRANÇAISESPAÑOLITALIANOJAPANESECOMPL & WARR
Auto Setup for Windows 3.1, Windows 95, Windows 98, Windows NT,
Windows 2000, Windows Me or Windows XP
To set up the monitor automatically in Windows 3.1, Windows 95, Windows
95, Windows 98, Windows NT, Windows 2000, Windows Me, or Windows XP,
do the following:
If the monitor is in standby
mode (STANDBY ON), it
may automatically turn off while
you are waiting for it to warm up.
1. Turn on the monitor first; then the computer.
If the message CHECK SIGNAL CABLE is displayed, or if nothing is
displayed, check:
• that the video interface cable is connected properly.
• the correct video adapter card is installed.
• the correct supported display mode is selected for your computer.
2. Wait approximately 15 minutes, until the monitor warms up.
3. Drag the icon bar and tool bar, if they are displayed, to the bottom of the
screen.
4. Insert the User’s Guide and Installation Files CD into the computer CD-
ROM drive.
The size and diversity of the
dot pattern varies with the
screen resolution.
5. Check the operating system installed on your computer and follow the
instructions from the table below.
Operating system
installation steps
6. When the test pattern appears, press the OSD Enter button at the
bottom of the monitor to display the initial OSD menu.
Position the mouse pointer
at the bottom center of the
screen. This allows
AUTO SETUP
to run properly
7. Use an Arrow button ( or ) to select the Image Setup icon
and press the OSD Enter button to access the function.
8. Using an Arrow button ( or ), select
AUTOMATIC and press the
OSD Enter button . This activates the
AUTO SETUP procedure, which
will optimize the display settings with the provided test pattern.
Operating
System
Step1 Step2 Step3 Step4
Windows 3.1
Open
P
ROGRAM
M
ANAGER
Select
F
ILE
Select
R
UN
Type
D:\TESTPAT
(change the
drive letter to
match your CD-
ROM drive if it
is not drive D)
and press
ENTER
Windows NT 3.5
Windows 95,
Windows 98,
Windows 2000,
Windows NT,
Windows Me or
Windows XP
Select
S
TART
Select RUN
L170P_E.fm Page 15 Tuesday, February 11, 2003 1:59 AM
