English – 39
TECHNICAL DATA
Recommended original and replacement bar and chain combinations
Following is a list of recommended cutting equipment for the Husqvarna chain saw model 455 Rancher 460. The combinations of
power head, bar and chain have been tested and found to be in accordance with the kickback and vibration requirements of ANSI
B 175.1–2000.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding
maximum nose radius of a solid bar.
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which will also
achieve kickback reduction.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be
considered to have equivalent kickback energy. A hard nose bar having the same length and nose radius as a sprocket-nose bar
may be considered to have equivalent or less kickback energy than the sprocket-nose bar.
Bar and chain combinations
Chain saw model Husqvarna 455 Rancher 460 met the kickback performance requirements of ANSI B 175.1-2000 when tested
with the combinations of bars and saw chains listed below. The saw chains Husqvarna H30, H80 and H81 are also classified as a
low kickback saw chain since it met the requirements for low kickback saw chain outlined in ANSI B 175.1-2000. We recommend
to use only the listed combinations of bars and chains for chain saw model Husqvarna 455 Rancher. Other chain saw models may
not meet the kickback requirements when equipped with the listed bar and chain combinations.
Bar Chain
Length, inch Pitch, inch
Thickness of drive
links, inch/mm
Max. nose
radius
Type
Drive link
count
13 0,325
1,3
10T
Husqvarna H30
56
15 0,325 10T 64
16 0,325 10T 66
18 0,325 10T 72
20 0,325 10T 80
13 0,325
1,5
10T
Husqvarna H25
56
15 0,325 10T 64
16 0,325 10T 66
18 0,325 10T 72
20 0,325 12T 80
15 3/8
1,5
11T
Husqvarna H42
56
16 3/8 11T 60
18 3/8 11T 68
20 3/8 11T 72
