4
Verify that the vehicle belt is
not twisted, then buckle (
Fig. D
)
.
5 While kneeling on the restraint
to push it firmly into the vehicle
backrest, remove all slack from the
vehicle belt.
•
First remove slack from the lap
portion of the vehicle belt, then
the shoulder portion (Fig. E).
6 Verify that the vehicle belt is
tight and the child restraint is
secure.
•
Refer to Figure F for correct routing
Removal
Reverse installation procedure.
Installation
15
Lap-Shoulder Belt Installation
Short Route
Figure A
illustrates a typical short
route lap-shoulder belt installation.
WARNING:
•
Always use the Versa-Tether
®
when installing restraint using
the short vehicle belt route
(
see
pages 18–19
)
.
•
Do not install this restraint using
a non-locking ELR vehicle belt,
unless a locking clip is used.
Refer to the vehicle owner's
manual for instructions on
correct use of vehicle belts with
child restraints.
1 Place the child restraint in a
forward facing position on the
vehicle seat.
2
Pull the vehicle belt out and pass it
through the first belt slot, from the
rear of the restraint to the front
(
Fig B
).
3
Route the vehicle belt under
the cover then through the
second belt slot, from the front of
the restraint to the rear
(
Fig. C
)
.
Installation
14
D
E
F
B
A
C
