16
Seat Installation
Attach Seat to Seat Post:
(pre-assembled on some models)
• Loosen nuts on seat clamp (A) and
rotate Seat (8) into riding position.
• Put the seat post (9) fully through the
seat clamp (A).
• Tighten the Seat Clamp so the seat
stays on the seat post.
• If the Seat Clamp has a nut on each
side, tighten both nuts equally.
g 06
A
9
8
CAUTION: If you accidentally drop the seat post into the seat tube, it may be
diffi cult to remove it.
• Point the Seat (8) forward and put the
Seat Post (9) into the Seat Tube (B)
(fi gs 07, 08).
WARNING: To prevent the seat com-
ing loose and possible loss of control, the
“MIN-IN” (minimum insertion) mark (C) on
the seat post must be below the top of the
Seat Tube.
8
C
B
9
C
g 07
B
Tighten the quick release lever:
• Move the Quick Release Lever (D) to
the “open” position so the word “open”
is pointing away from the Seat Post
Clamp (E).
NOTE: The words “open” and “close” are on
opposite sides of the quick release lever.
g 08
E
B
F
9
D
Assembly
