37
Release Notes for 07.8.04 Software Fixes
47254 On an EP 8 Port Mini-GBIC Redundant
Management module, when you configure sFlow
and an ACL so that packets that were being
forwarded by the CPU are filtered by the ACL, an
incorrect VLAN ID is matched with the ACL.
ACL 07.8.02
47542 A system reload may occur when you enter a show
run command during a Telnet session in which you
bind ACLs to a port.
ACL/Telnet 07.8.02
47724 When you enter the show ip bgp neighbor <x>
adv command, all advertised routes are not always
displayed, although the routes are advertised
correctly.
BGP 07.8.02
47725 On an EP 48-Port 10/1000-TX RJ45 module,
binding and unbinding a single ACL-based rate
limiting policy too many times causes memory
corruption and results in a system reload.
Rate Limiting 07.8.02
48474 On an EP 8 Port Mini-GBIC Redundant
Management module, when MRP2 is enabled and
hellos are sent, a member ring blocked the port,
instead of processing and forwarding hellos. Only
the master ring should block the port.
MRP2 07.8.02
48521 On an EP 8 Port Mini-GBIC Redundant
Management module, disabling a port on one MRP
ring causes a port on a different ring in a blocking
state to transit through the forwarding state.
MRP 07.8.02
48525 On an EP 8 Port Mini-GBIC Redundant
Management module, you are not allowed to
configure a static trunk if the ports in the trunk are
members of an MRP2 ring.
MRP 07.8.02
48587 On an EP 8 Port Mini-GBIC Redundant
Management module, when you change the
primary and secondary port of a lower priority ring,
ports on the higher priority ring are affected.
MRP 07.8.02
48660 On an EP 8 Port Mini-GBIC Redundant
Management module, after an SSH key is
generated, you are incorrectly prompted for a
configuration change immediately after you enter
the write memory command.
System 07.8.02
48747 When you reboot a routing switch with an EP 48-
Port 10/1000-TX RJ45 module on which MRP is
configured, a debug error message is displayed on
neighbor devices, even after a neighbor has
stabilized.
MRP 07.8.02
48753 On an EP 8 Port Mini-GBIC Redundant
Management module, 10 seconds to 3 minutes are
required for traffic to recover after a failed MRP link
returns to a forwarding state.
MRP 07.8.02
Bug ID Bug Description Protocol/
Feature
Version
Found
Version
Fixed
