Using Authorized IP Managers
Defining Authorized Management Stations
2. Enter an Authorized Manager IP address here.
5. Press [Enter], then [S] (for Save) to configure the
IP Authorized Manager entry.
3. Use the default mask to allow access by one
management device, or edit the mask to allow
access by a block of management devices. See
“Building IP Masks”on page 8-9.
4. Use the Space bar to select Manager or Operator
access.
Figure 8-2. Example of How To Add an Authorized Manager Entry (Continued)
Editing or Deleting an Authorized Manager Entry. Go to the IP Manag-
ers List screen (figure
8-1), highlight the desired entry, and press
[E] (for Edit)
or
[D] (for Delete).
CLI: Viewing and Configuring Authorized IP Managers
Authorized IP Managers Commands Used in This Section
Command Page
show ip authorized-managers below
ip authorized-managers 8-7
<ip-address> 8-8
mask <mask-bits> 8-8
<operator | manager>
Listing the Switch’s Current Authorized IP Manager(s)
Use the show ip authorized-managers command to list IP stations authorized to
access the switch. For example:
Figure 8-3. Example of the Show IP Authorized-Manager Display
8-6
