Warnings
WARNING
MOVING PARTS HAZARD
Moving parts can pinch, cut or amputate fingers and other body parts.
• Keep clear of moving parts.
• Do not operate equipment with protective guards or covers removed.
•Pressurized
equipment can start without warning. Before checking, moving, or servicing
equipment, f
ollow the Pressure Relief Procedure and disconnect all power sources.
TOXIC FLUID
OR FUMES
Toxic fluids
or fumes can cause serious injury or death if splashed in the eyes or on skin,
inhaled, or
swallowed.
• Read MSDSs to know the specific hazards of the fluids you are using.
• Store haza
rdous fluid in approved containers, and dispose of it according to applicable
guideline
s.
• Always wear chemically impermeable gloves when spraying, dispensing, or cleaning
equipment.
PERSONAL PROTECTIVE EQUIPMENT
Wear appropriate protective equipment when in the work area to help prevent serious injury,
including eye injury, hearing loss, inhalation of toxic fumes, and burns. This protective
equipment includes but is not limited to:
• Protective eyewear, and hearing protection.
• Respirators, protective clothing, and gloves as recommended by the fluid and solvent
manufacturer.
EQUIPM
ENT MISUSE HAZARD
Misuse
can cause death or serious injury.
• Do not operate the unit when fatigued or under the influence of drugs or alcohol.
•Donot
exceed the maximum working pressure or temperature rating of the lowest rated
syste
m component. See Technical Data in all equipment manuals.
• Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data
in all equipment manuals. Read fluid and solvent manufacturer’s warnings. For complete
information about your material, request MSDS from distributor or retailer.
• Do not leave the work area while equipment is energized or under pressure.
•Turn
off all equipment and follow the Pressure Relief Procedure when equipment is not in use.
• Check equipment daily. Repair or replace worn or damaged parts immediately with genuine
manufacturer’s replacement parts only.
• Do not alter or modify equipment. Alterations or modifications may void agency approvals
and create safety hazards.
•Mak
e sure all equipment is rated and approved for the environment in which you are using it.
• Use equipment only for its intended purpose. Call your distributor for information.
• Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.
•Do
not kink or over bend hoses or use hoses to pull equipment.
• Keep children and animals away from work area.
• Comply with all applicable safety regulations.
4
332339B
