ZX12B30PSS, ZX12B36PSS, ZX12B48PSS Accessory Installation
OPTIONAL ACCESSORIES—12" HIGH BACKSPLASH
TOOLS AND MATERIALS REQUIRED
•
Glov
es to pr
otect against sharp edges
• T-15 and #2 Phillips screwdrivers
• Drill with 3/32" and 9/64" bits
•
Safety glasses
• Level
• Pencil
This Kit Includes
• Wall support panel
•
Cov
er panel
•
Har
dware package with
– 5 Stainless S
teel T
or
x 15 #8
self-tapping screws
– 5 Phillips #2 pan head w
ood
#10 screws
Wall Support
Panel
Har
dwar
e
Package
INSTALL 12" BACKSPLASH
WARNING: This backsplash must
be securely fastened to the wall. Failure to do
so could result in damage or personal injury.
• Install and level the range or rangetop and the
range hood according to the installation
instructions.
• Remove the backsplash packaging and
protective film.
• Use a level to pencil a horizontal line on the wall,
1/8" above the range or rangetop. The 1/8" gap
allows the cover panel to overlap the wall support
panel.
• Locate wall studs on each side. Where studs are not
av
ailable, plan to use wall anchors (not provided).
• Align the wall support panel on the marked
horizontal line and centered left to right
.
• The wall support panel must be secured to the wall
at all 4 corner
s. Use wood screws (provided) or wall
anchors (not provided) to secure the support panel
to the wall.
• Place the cover panel over the wall support
panel and secure with Torx screws (provided).
Install 2 screws on each side.
Install 4 Wood
Screws
1/8″
Install T-15
Screws
W
all
Support
Panel
Wall Support
Panel
Cover Panel
18
Cover Panel
WARNING:
To prevent ignition of combustible materials,
the entire back wall above the range must
be protected by a backsplash constructed
of non-combustible material.
This stainless steel backsplash accessory
must be installed in combination with a custom,
non-combustible backsplash built beyond
the 12" height of the backsplash.
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
IMPORTANT: Save these instructions for local
inspector’s use.
IMPOR
TANT: OBSERVE ALL GOVERNING CODES
AND ORDINANCES
.
NO
TE TO INSTALLER: Be sure to leave these
instructions with the Consumer.
NOTE TO CONSUMER: Keep these instructions
with your Owner’s Manual for f
uture refer
ence.
This kit pr
ovides for the installation of a 12" high
backsplash for 30", 36" or 48" Monogram
Professional Ranges and Rangetops.
Center
Arrow
