~
Questions?
Use This Problem Solver
~
PROBLEM POSSIBLE CAUSEAND REMEDY
..
,...
.,%.
“.*.$,..
‘<#>*if.:!&-..c
WASHEROR DRYER
● Make sure controls are p~prly ‘Set‘~d ~&er cycleselectoris pulled out or dryer ~~.
WON’TSTART
STARTbutton is pushed. . . ,,, ,.$&,, => ~~~~,
.;‘%2‘f.;.!..
%,
● Applimce unplugged. Make sure Cordis firmly plugged into electrical outlet.
● NOpower to appliance. Check f&es ndiircuit breakers to make sure appliance is
getting current.
. . . ...
.-.~.;
,,..<”?
~y:”%-
.:.”
-----
. Dryer door is open. Dryer will not ~ wi~’’d~’~~pen. Make sure washer lid k+C]O&d.
Washer will fill but will not spin with lid o~n::. -, ~
. .&.~.,:. .+
. Make sure bo~ hot and ~ld ~uce$&&&&&”~-~h~T:~.~~ ;‘~
.’, .
:..-i .+
2-.
.,
.“”...
.,’:?...
.<
WON’TDRAIN
. Kinked or pinched hose. Check and correct.
● Topofdrain outlet should be less than 8feetabovethe floor.
WATERLEAKS
● Make sure hose connections are tight atfaucets.
● Make sure end ofdrain hose is correc~y insefied into and secured to drain facility.
WASHERWON’T
● Lid not closed. Washerwill not progress through spin cyclewith lid up. Make sure lid
SPIN AND isclosed. Lid will be automatically locked during spin portion for safety.
COMPLETE CYCLE
CL~HES ARE
● Load mayhavebeen excessive y out ofbalance. Redistribute clothes and rerun through
ABNORMALLY
final spin.
WET AFTER SPIN
APPLIANCE IS
● Me~llic “clicks” heard as timer advances during operation are normal.
NOISY
● Unevenfloor. Make sure appliance is level ad fkm to floor.
● Heavi]y unbalanced loads can causethe washer to vibrate excessively during spin, and
maycause it to movefrom its original position. In extreme cases, (usually occurs when
washing a single, heavy item or asmall load when waterlevel is set higher than
necessary) the spin basket maystrike tie outer tub, creating aloud but harmless noise.
Tocorrect, open the lid and redistribute the load evenly about the wash basket. Close the
lid and restart.
WATERDOES NOT
. Faucets turned off. Make sure faucetsare on andadjusted coITectly.
ENTER OR ENTERS
SLOWLY
● Hoses kinked. Check and correct.
● clogged screen in water valve. Unscrew fill hose from washer and clean screen if
necessary. When reassembling, make handtight PIUS1/3turn with pliers.
18
