3.3 fi-5000N's Settings and Connecting to the Network
fi-5000N Operator’s Guide 17
Installing the fi-5000N
3
12. Press the [K] or [L] key to select one from among "Auto Negotiation", "100BASE-TX
Full", "100BASE-TX Half", "10BASE-TX Full" and "10BASE-TX Half", and press the
[ENT] key.
Usually "Auto Negotiation" is selected. The following
network settings confirmation screen appears when you
press the [ENT] key.
If the hub to connect fi-5000N does not support Auto nego-
tiation, select the supported Speed/Duplex setting.
13. Confirm the contents of the settings.
To change the settings, press the [ESC] key until it returns
to the setting screen of the item to change, and configure
again.
If the contents are correct, press the [ENT] key. The follow-
ing screen appears.
With this, the network settings are completed.
Select "Auto Negotiation" if the hub supports auto negotiation function. If
auto negotiation function is not supported, select the Speed/Duplex that is
supported by the hub. The network communication may fail if the following
settings are done:
• When "100Base-TX Full" or "Base-TX Full" is selected for a hub that only
supports auto negotiation.
• When "Auto Negotiation" is selected for a hub that does not support auto
negotiation.
• When the selected Speed/Duplex is not supported by the hub.
For a correct connection and conditions, refer to the manual of the Ethernet
hub.
If the fi-5000N is initialized, the settings done in this section will return to their
default values. In order not to forget the settings done in this section, make a
note of them.
When "Use DHCP" is selected in step 7, it is not necessary to note down for IP
address, Subnet mask and Default gateway.
IP :XXX.XXX.XXX
MASK:XXX.XXX.XXX
GW :XXX.XXX.XXX
OK:[ENT]/NG:[ESC]
MEMO
IP address: ................................
Subnet mask: .............................
Default gateway ..........................
DNS 1: .......................................
DNS 2: .......................................
