En-2
Fig. 1 Indoor Unit
1 Operating Control Panel (Fig. 2)
2 AIR CLEANER RESET / MANUAL AUTO
button
●
Intake grill opening mechanism.
When the remote control is not available
for use, this button can be used as a Quick-
start button. However when the Air
Cleaning check function (see page 13) is
in operation, this button is used as a reset
button.
3 Indicator Lamps (Fig. 3)
4 Remote Control Signal Receiver
5 OPERATION Indicator Lamp (red)
6 TIMER Indicator Lamp (green)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See Page 17 Auto Restart).
7 AIR CLEAN Indicator Lamp (green)
8 COIL DRY Indicator Lamp (orange)
9 Intake Grille (Fig. 4)
0 Air Filter
A Air Flow Direction Louver
B Right-Left Louver
(behind Air Flow Direction Louver)
C Drain Hose
D Electrical Air Cleaning Filter
Fig. 5 Remote Control Unit
E MASTER CONTROL button
F SET TEMP. buttons (5/∞)
G Signal Transmitter
H TIMER MODE button
I FAN CONTROL button
J START/STOP button
K AIR CLEAN button
L SET button
M SWING button
N RESET button
O CLOCK ADJUST button
P TEST RUN button
● Perform a test run only when installing the
air conditioner. If the signal to perform a
test run is received during normal opera-
tion, the air conditioner’s thermostat will
malfunction.
● If the signal to perform a test run is re-
ceived during normal operation, the unit
will switch to the test operation mode and
the indoor unit’s OPERATION and TIMER
indicator lamps will flash simultaneously.
● To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
Q COIL DRY button
R SLEEP button
S SET TIME button (+/–)
T Remote Control Unit Display (Fig. 6)
U Transmit Indicator
V Clock Display
W Operating Mode Display
X Timer Mode Display
Y Fan Speed Display
Z Temperature Set Display
[ SWING Display
\ AIR CLEAN Display
] COIL DRY Display
● Refer to the folded out page on the cover.
NAME OF PARTS
9373420026_OM_en.p65 9/12/05, 15:402
