Fisher-Price W1070 Manual

A SERVICE OF

next previous

W1070pr-0920

13

21

•Iftheclipisupsidedownornotthroughbothholesin

the axle, you have not assembled it properly. Please

remove the clip and go back to step 18.

CORRECT

INCORRECT

INCORRECT

ASSEMBLY

•Insertthe"T"fastenerendofashortseatbeltstrap

down through the slot near the outer edge of the

seat. Make sure the fastener side of the seat belt

faces inward.

Note: You will pull only one T-Loop through the slot.

•Repeatthisproceduretoassembletheothershortseat

belt strap.

•Inserteachfastenerendofthelongseatbeltstrapup

through the slots in the center of the seat. Make sure

the fasteners face the outer edge of the seat.

•Pulleachsideofthelongseatbeltstrapevenly

through the slots. Make sure to pull each T-loop

through a slot.

23

Short Seat Belts

Long Seat Belt

•Alignthetabsonahubcapwiththeslotsinarear

wheel. “Snap” a hubcap into the center of the

rear wheel.

Hint: If the hubcap does not "snap" into place, you may

not have assembled the wire clip properly. Remove the

wire clip and refer back to step 19.

•Repeatsteps18-22toassembletheotherrearwheel,

wire clip and hubcap.

22

Hubcap