Care and Maintenance
34
Cover Removal
1. Loosen the harness by lifting the harness adjuster located in the front of the restraint,
and pull the harness straps forward.
2. Unhook the harness straps from the yoke on the back of restraint.
3. Unbuckle harness from the buckle.
4.
Pull upper harness straps through the shell and cover to the top of the restraint.
5. Gently remove the upper portion of the cover. Be careful not to damage the energy-
absorbing foam.
6. Pull the lower harness straps, buckle tongues, chest clip and buckle through the slots
in the cover.
7. Remove cover from the restraint.
Cover Replacement
To replace the cover, reverse removal directions above. Make sure that the harness straps are
threaded through the chest clip and that the harness is not twisted.
WARNING
• Do not take apart or attempt to take apart the harness. It is
unnecessary and dangerous to do so.
• Never remove the buckle tongues from the harness. They cannot
be reattached after removal.
35
Cleaning the Cover
• Hand wash, using cold water and mild soap.
• Line dry to prevent cover from shrinking.
• Do not bleach, machine wash, machine dry, or iron.
Cleaning the Shell and Harness
• Brush away loose debris, using a soft-bristle brush.
• Sponge clean, using warm water and mild soap.
• Towel dry.
• Do not use solvents, abrasive cleaners, or bleach. Do not machine wash, machine dry, or
disassemble the harness.
Cleaning the Harness Adjuster
• Brush away loose debris, using a soft-bristle brush.
• Sponge clean, using warm water and mild soap.
• Towel dry.
• Do not use solvents or abrasive cleaners, or disassemble the harness.
Care and Maintenance
WARNING
Periodically check the adjuster area to be sure it is clean and free of
food, coins, dirt, and other objects. If debris is present, it must be
removed to prevent interference with the adjuster mechanism.
