Assembly
1
• Press and fit the two small ramps on to the main base.
• Press and fit the two large ramps on to the main base.
Town Hall
2
• Place the main base on a hard flat surface.
• “Snap” the Town Hall into the main base.
Small Ramp Small Ramp
Large RampLarge Ramp
Main Base
Main Base
Battery Installation
3
Battery Compartment Door
• Locate the battery compartment on the bottom of the main base.
• Loosen the screws in the battery compartment door with a Phillips
screwdriver. Remove the battery compartment door.
• Insert three “C” (LR14) alkaline batteries, as indicated inside the bat-
tery compartment.
Hint: We recommend using alkaline batteries for longer life.
• Replace the battery compartment door and tighten the screws with a
Phillips screwdriver. Do not over-tighten.
• When sounds or motions from this toy become faint or stop, it’s time for
an adult to change the batteries!
1.5V x 3
"C" (LR14)
SHOWN ACTUAL SIZE
Batteries may leak fluids that can cause a chemical burn injury or ruin
your toy. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types:
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove
exhausted batteries from the toy. Dispose of batteries safely. Do not
dispose of batteries in a fire. The batteries may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging.
• If removable, rechargeable batteries are used, they are only to be
charged under adult supervision.
