11
Assembly
Dash
• Replace the sound and light unit into the dash.
• Insert three #10 x
1
/
2
" screws into the unit, as shown.
Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Sound and Light Unit
5
• Insert three “AA” (LR6) alkaline batteries, as indicated
inside the battery compartment.
• To replace the battery compartment door, fit the tab
on the door into the slot in the unit and lower to close.
Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
• When sound becomes faint or stops, it's time to replace
the batteries!
Battery Safety Information
Batteries may leak fluids that can cause a chem-
ical burn injury or ruin your product.To avoid bat-
tery leakage:
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the bat-
tery compartment.
• Remove batteries during long periods of non-use.
Always remove exhausted batteries from the product.
Dispose of batteries safely. Do not dispose of batteries
in a fire. The batteries may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• If removable, rechargeable batteries are used, they are
only to be charged under adult supervision.
Battery
Compartment
Battery Compartment Door
Tab
1.5V x 3
“AA” (LR6)
4
Dash
• Position the dash face down.
• Remove the backing from a wire clip. Throw the
backing away.
• Press the wire clip into place, as shown, on the dash.
IMPORTANT! The wire clip should open up.
Wire Clip
Opens Up
6
Sound and Light Unit Wire
Wire Clip
• Fit the sound and light unit wire into the wire clip.
7
SHOWN ACTUAL SIZE
