10
Installation instructions
Fastening the cooktop to the bench
This cooktop is suppled with fastening brackets (and screws) that will cope with a
bench thickness of 20-50 mm. For benches thicker than 50 mm, recess the underside
to a thickness of 20-50 mm.
Connecting the cooktop to the gas supply
Important!
This cooktop is supplied factory-set for Natural gas, but is suitable for installation with either
Natural gas or LPG, provided the injectors appropriate for the gas type are installed. Refer to
section ‘Gas supply and gas rate summary’ for nominal ratings and appropriate injector sizes,
and to section ‘Converting to a different gas type’.
Gas products MUST be installed and tested by a suitably qualified and registered person in
accordance with all regulations and standards applicable to the country of installation.
Make sure the connection point will be accessible with the cooktop installed.
To enable the gas supply to be readily shut off, make sure the connection is fitted with an
isolating valve close to the cooktop.
For instructions on converting the cooktop for use with a different gas type, see section
‘Converting to a different gas type’.
20 mm
50 mm
recessed to
50 mm
Fig.1 Fastening the cooktop to the bench
