P/2 DA8 and P/2 DA12 • Installation and Operation
2-9
Video Input and Output Connections
All models are able to accept RGBHV, RGBS, RGsB, RsGsBs,
YUV (tri-level and bi-level sync), S-video and composite video,
and resolutions from VGA (640 x 480) to QXGA (2048 x 1536).
The signal is distributed without modification: the output
format follows the input format.
To make input and output connections with other devices,
follow these instructions:
1. Turn off the power to the distribution amplifier and the
video source.
2. Connect the video source to the 15-pin female HD input
socket on the rear panel of the distribution amplifier.
3. Connect the display devices to the 15-pin female HD
output sockets on the rear panel of the distribution
amplifier.
N
ID bits on pins 4, 11, 12, and 15 are routed to Output 1.
N
For optimal performance, all display devices should have
similar resolution capabilities.
N
For sources and displays that require different
connectors, use an HD adapter cable, such as the Extron
SY BNCM series (#26-533-xx; see the figure below, at
left). The BNC connectors used for different signal types
are shown in the figure below, at right.
S-video
G
B
R
H
V
RGsB,
RsGsBs,
Component
G
B
H
V
R
Composite
R
G
B
H
V
RGBHV
G
B
H
V
R
RGBS
RG
B
V
H
Figure 2-5 — Video Connections
