PictureMate Deluxe Viewer Edition
8 - PictureMate Deluxe Viewer Edition 4/05
Warning: Keep ink cartridges out of the reach of children and do
not drink the ink.
If ink gets on your hands, wash them thoroughly with soap and
water. If ink gets in your eyes, flush them thoroughly with
water. If discomfort or vision problems continue after flushing,
see a doctor immediately.
Inserting the New Photo Cartridge
1. Shake the cartridge four or five times while it is still
wrapped in its packaging.
2. Unwrap the cartridge.
Caution: Don’t touch the green circuit board. Install the photo
cartridge immediately after you remove it from its package. If
you leave a cartridge unpacked for a long time before using it,
normal printing may not be possible.
3. Make sure the lever is moved to the left before you insert
the cartridge, then carefully slide the cartridge, label side up,
into the slot.
4. Push in both sides of the cartridge evenly to make sure it is
not crooked. It won’t go in all the way.
5. Move the lever to the
Lock position by sliding it in the
direction shown.
6. Close the cartridge door. Make sure it snaps shut.
7. Lower the handle.
Cleaning the Print Head
If your print quality is not as good as it used to be, if your
photos are too light, or if they are missing colors or have lines
running through them, PictureMate’s print head nozzles may
be clogged.
Follow these steps to clean the print head:
1. Press the
Menu button.
2. Press or to highlight
Maintenance.
3. Press to open the Maintenance menu.
4. Make sure
Clean Print Head is selected, then press . You
see this message:
5. Press
OK to begin cleaning the print head.
The cleaning process takes about 40 seconds. PictureMate
makes some noise, and you see the following message on the
screen:
Caution: Never turn off PictureMate while it is cleaning its print
head, unless it hasn’t moved or made noise for more than
5 minutes.
Lever
