45
GB
APPENDIX
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
Remote Control
Units dose not work.
● Check the batteries.
● Check the ALL-OFF switch on the Remote Control Unit is set to “ON.”.
● Make sure anything is blocking between the Remote Receiver and the Remote Control
Units.
● Make sure you are not too far from the projector when using the Remote Control Units.
Maximum operating range is 5m.
Problem: Try these Solution
Wireless Mouse
function does not
work.
● Check the cable connection between the projector and the computer.
● Check the mouse setting on your computer.
● Turn the projector before your turn on the computer.
The image data in
memory card isn’t
displayed.
● Check the memory card is inserted properly into PC CARD SLOT.
● Check SmartMedia or PC Card Adapter is set properly.
● Check MCI mode is selected.
● Check the image data is recorded in the memory card properly.
● Start the projector again.
The image data can’t
be written in, read
from the memory
card.
● Check the projector is turned on.
● Check “Card access” in VIEW menu is selected.
● Check Control Cable for Serial Port (optional) is connected properly.
● Check the memory card is inserted properly into PC CARD SLOT.
● Check Media Card Imager (supplied) is installed in your computer properly.
● Check the setting in Media Card Imager (like Serial Port Setting) is set properly.
