11
Part Names and Functions
Rear Terminal
⑫ S-VIDEO IN
Connect the S-VIDEO output signal from video
equipment to this jack (p.20).
⑨ AUDIO IN
Connect the audio output signal from video
equipment connected to ⑧ or ⑫ to this jack. For a
mono audio signal (a single audio jack), connect it
to the L (MONO) jack (p.20).
⑩ COMPUTER/COMPONENT AUDIO IN
Connect the audio output (stereo) signal from a
computer or video equipment connected to ④ or ⑥
to this jack (pp.19, 21).
⑧ VIDEO IN
Connect the composite video output signal to this
jack (p.20).
④ COMPUTER IN 2/COMPONENT IN
Connect the computer or component video (or RGB
Scart) output signal to this terminal (pp.19, 21).
Use the supplied VGA cable or a Component-VGA
cable commercially available.
⑪ AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack
(pp.19–21).
This terminal outputs sound from AUDIO IN terminal
( ⑨ or ⑩ ).
① R/C JACK
When using the wired remote control, connect
the wired remote control to this jack with a remote
control cable (supplied).
③ SERVICE PORT
This jack is used to service the projector.
⑥ COMPUTER IN 1/DVI-I
Connect computer output (Digital/Analog DVI-I
type) to this terminal (p.19).
⑬ SD Card Indicator
Display the status of SD card.When inserting SD
Card, the indicator lights, and when removing SD
Card, the indicator turns off.
⑦ LAN Connection Terminal
Connect the LAN cable (Refer to the owner's
manual of "Network Set-up and Operation".).
① ② ③ ④ ⑤ ⑥
⑦
⑧ ⑨ ⑩
② USB
In order to operate the computer with the remote
control and use the PAGE
▲▼ buttons on the
remote control during a presentation, connect the
USB port of the computer to the USB terminal with
a USB cable (not supplied) (pp.13, 19).
⑤ MONITOR OUT
This terminal can be used to output the incoming
RGB analog signal from COMPUTER IN 1 and
COMPUTER IN 2/COMPONENT IN terminal to the
other monitor (p.19).
⑪
⑫
⑬
⑭ SD Card Slot
Insert the SD card memory (not supplied) for
Memory viewer operation.
⑭
