54
Setting
This function allows you to change brightness of the
screen.
Normal ...... Normal brightness
Eco ............ Lower brightness reduces the lamp
power consumption and extends the
lamp life.
Lamp control
Lamp life control
Lamp control
Select the lamp operation when the total lighting time of a
lamp exceeds the recommended total hours of use.
Mode 1 .............. The lamp can be turned on even after
exceeding the recommended total
hours of use.
Mode 2 .............. The lamp can be turned on even after
exceeding the recommended total
hours of use. But the projector turns off
automatically after 3 minutes.
Lamp life control
✔ Note:
• Lamp mode cannot be changed for a while after turning
on the projector. Lamp needs some time to stabilize
after the power is turned on. Stored lamp mode will be
active after the lamp is stabilized.
• If Mode 2 has been selected and the projection lamp
exceedes the recommended total hours of use, the
replacement icon will be displayed at the time of power-
on. Then the projector will turn off after 3 minutes.
• The Lamp replacement icon will not appear when the
Display function is set to Off (p.48), during Freeze
(p.27), or No show (p.28).
Lamp replacement icon
Standby mode
This function is available when operating the projector via
network.
Normal ...... Supply the power to the network function even
after turning off the projector. You can turn on/
off the projector via network, modify network
environment, and receive an e-mail about
projector status while the projector is powered
off.
Eco ............ Select Eco when you do not use the projector
via network. The projector’s network function
will stop when turning off the projector.
Refer to the owner’s manual “Network Set-up and
Operation”.
✔ Note:
• Factory default is Eco.
• When selecting Normal, the cooling fans may be running
depending on the temperature inside the projector even if
the projector is turned off.
