- 3 -
E
LENS LOCK RELEASE
LENS LOCK SCREW
DRIVER
IN THE LENS
LOCATE MOTOR
ON RIGHT SIDE
LENS ATTACHMENT
Part No. (610 275 6029)
Fig-4
Fig-6 Fig-7
LENS LOCK
LEVER
LENS LOCK
4
Replace the Lens Cap on the rear (mounting side) of the Projection Lens and mount a lens on
the Lens Attachment with four (4) Screws. (Use the screws attached on the lens.)
Connect the Lens Motor Lead connector to the socket on the right-top of the Lens Attachment
(Motor Driven Lens only). See Fig. 5.
When installing the LNS-W01, LNS-W01Z, LNS-T01, LNS-T01Z, be sure to mount the lens and
the Light-Block Sheet Mounting Base on the Lens Mounting Bracket. (See Fig. 8)
LIGHT-BLOCK SHEET
MOUNTING BASE
Part No. (610 303 9596)
Kit parts with two (2) screws.
5
Grasp (release lock) the Lens Lock Lever and turn it fully upward. (See Fig. 6.)
Install the lens into the projector. Grasp the Lens Lock Lever and turn the Lever fully downward
until lever is Locked (clicked position) properly. (See Fig. 7.)
When installing the Motor Driven Lens, be sure to mount the Lens Motor on the right side. (See Fig. 5.)
After installing the lens, make sure the lens is not loose and properly installed.
CONNECTOR
LENS MOTOR LEAD
Fig-5
LENS
ATTACHMENT
SOCKET
Lens attachments For each lens.
LNS-W01, LNS-W01Z, LNS-W02Z,
LNS-W03, LNS-T01, LNS-T01Z,
LNS-T02, LNS-S02, LNS-S02Z,
LNS-S03, LNS-M01Z, LNS-W04,
LNS-W05, LNS-W06, LNS-W07
Lens Attachment 01
POA-LNA-01
(610 303 8742)
LNS-W02, LNS-M01, LNS-S01
Lens Attachment 02
POA-LNA-02
(610 304 6228)
Lens Model No.
LENS ATTACHMENT
TYPE No. (PART No.)
Grasp (unlock)
the Lens Lock
Lever and pull
upward.
Grasp (unlock) the
Lens Lock Lever and
fully pull downward
until it is locked
(clicked).
