33
Basic Use
This chapter describes different basic methods of connecting the UM-1EX according to how the
UM-1EX is to be used.
To transmit MIDI messages from a MIDI keyboard or digital piano to the sequencer software or
make a MIDI recording of a keyboard performance or other performance using sequencer
software on your computer, make the following connections and settings.
fig.connect-in_e
MIDI device setting
* Make the device settings within the sequencer software.
THRU switch setting
MIDI messages from the MIDI device (e.g, MIDI keyboard, digital piano) connected to the UM-1EX’s MIDI IN
cable are transmitted to the computer.
* Don't change the setting of the
THRU switch
while you're using the UM-1EX. Doing so will cause MIDI errors.
Basic Connections and MIDI Flow
Transmitting MIDI messages from a MIDI keyboard or digital
piano to the sequencer software
MIDI IN
UM-1 MIDI
THRU Switch
OFF
MIDI Keyboard
Digital Piano
MIDI messages are transmitted
to the sequencer software.
Connect to the MIDI OUT connector
of the MIDI keyboard or digital piano.
MIDI Message Flow
Message Flow
Connect to the
computer’s
USB connector.
THRU OFF
If you are experiencing duplicate notes (i.e., if your sound generating device plays two notes for each note it should play), turn
Local Control OFF on your sound generating device, or turn the Thru function OFF in your sequencer software. For details on
how to make these settings, refer to the owner’s manual for your equipment.
UM-1EX_multi1.book 33 ページ ２００５年１１月１日 火曜日 午後３時１９分
