English
3
SPECIFICATIONS
Laser Power < 1 mw, CLASS 2 LASER
PRODUCT
Range [at 70°F (22°C)] 1'–100' (300 mm–30 m)
Accuracy [at 70°F (22°C)] ± 1/8" (3 mm)
Power Source two AAA (LR03) size batteries
Battery Voltage 2 x 1.5 V
DC
Storage Temperature 20°F to 160°F (–7°C to 70°C)
INTENDED OPERATING CONDITIONS
Environmental Indoor and Outdoor
Water resistant
Temperature 20°F to 120°F (–7°C to 50°C)
Relative Humidity ≤ 85%
Air Quality Pollution Degree 3
Altitude ≤ 11,500' (3,500 m)
LASER OPERATION
• To extend battery life per charge, turn the laser off when it is not
in use.
• To ensure the accuracy of your work, check the laser
calibration often. Refer to Field Calibration Check under
Laser Maintenance.
• Before attempting to use the laser, make sure the device does
not show any defects and is in proper working order.
• Extreme temperature changes can cause movement or shifting
of building structures, metal tripods, equipment, etc., which can
effect accuracy. Check your accuracy often while working.
• If the device is dropped or has suffers a sharp blow, have the unit
checked by a qualified service center before using the laser.
Important Safety Instructions
for Batteries
WARNING: Batteries can explode, or leak, and can cause
injury or fire. To reduce this risk:
• Carefully follow all instructions and warnings on the battery label
and package.
• Always insert batteries correctly with regard to polarity (+ and –),
marked on the battery and the equipment.
• Do not short battery terminals.
• Do not charge batteries.
• Do not mix old and new batteries. Replace all of them at the
same time with new batteries of the same brand and type.
• Remove dead batteries immediately and dispose of per local
codes.
• Do not dispose of batteries in fire.
• Keep batteries out of reach of children.
• Remove batteries if the device will not be used for several
months.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
Installing and Removing Battery (Fig. 2)
NOTE: This Laser Distance Measurer (LDM) is powered by two
AAA (LR03) size 1.5
V
DC
batteries.
INSTALLING THE BATTERY PACK
1. Lift up the battery compartment cover (A) as shown
in Figure 2.
