4
Lighting Heater
Read and understand all safety information before operating heater.
1. WARNING: Make sure there is no open flame in the area. Make sure there are no flam-
mable vapors or liquids in the area during lighting. Fully open the propane tank valve.
2. Turn the heater regulator knob counterclockwise to the “HI” position.
3. WARNING: Stand to the side of the heater while lighting. Do not stand or have any part of
your body in front of heater while lighting. Locate ignition hole in underside of burner (see
Figure 3). Hold a lit match under ignition hole.
CAUTION: Do not insert match into air inlet holes in mixing tube. Push in the safety shutoff
valve plunger (see Figure 3). WARNING: Do not push in safety shutoff valve plunger before
inserting lit match. Burner should light. Mesh screen on burner glows red when lit. After burner
is lit, continue holding in safety shutoff valve plunger for 10 to 30 seconds until heater stays lit.
4. If the burner does not light within 30 seconds, turn the regulator knob to the “OFF” position. Wait
at least two minutes for the gas to dissipate before relighting.
5. If heater will not light after repeated trys, do not attempt to repair heater. Return heater to nearest
authorized service center or to address on back page of this manual, freight prepaid.
6. After heater stays lit, turn the heater regulator knob to the desired heat setting (LOW, MED, or HI).
Ignition Hole
Figure 3
Figure 2
Safety Shutoff
Valve Plunger
Air Inlet
Hole
To Turn Off Heater
1. Tightly close propane tank valve by turning clockwise.
2. Turn the heater regulator knob to the “OFF” position. Wait at least 15 minutes for the heater to
cool before handling heater.
Heater
Regulator
Knob
