
page 9
10. Automated Learning Process./Activating Code.
4
1
2
12V
1234
D
3
5
6
ON
BACK
SET
ON ECE
Remove battery cover on back side of remote control transmitter.
Install 12-volt battery (provided) in transmitter.
IMPORTANT: Store the transmitter away from excess heat or humidity. To prevent damage to transmitter,
remove the battery if not used for long periods.
Fan SPEED control buttons1: Use to control the ceiling fan speed 1-6
Fan OFF button 2: Use to turn the fan off
REVERSE function button 3: Use to control fan direction
LIGHTING button 4: Use to control down-light and up-light (if applicable)
CODE SWITCHES and SET button 5: With fan power off, arrange CODE SWITCHES to desired code
setting. Restore electrical power, press and hold SET button on
back of remote control for 5 seconds within 60 seconds of
powering fan in order to synchronize with fan motor.
DIMMING function 6: Dimming capability is determined by the type of bulbs provided
with the fan. If no bulbs are provided, dimming function will
not work.
OFF position = D On position = ON
Replace the battery cover on transmitter.
I
II
IV
VI
III
V
remote control
5