Combi Flash EX 655 Manual

Open as PDF

next previous

Attaching/Releasing Infant Seat

- 6 -

Trade name and trademarks of Graco

, Century

, Evenflo

and Cosco

and Peg-Perego are the property of their respective owners and no endorse-

ment of or approval by them is intended or implied. All

Combi Flash EX

strollers are compatible with specified models of the Graco

, Century

Evenflo

®,

and the

Peg-Perego

infant car seat/carrier models

as of the date this printing was prepared.

ombi USA Inc.

Unbuck

le the

attachment

strap and lay

over the right

and left side

of the stroller

rame.

Hook the infant

seat onto front

rail of the stroller.

The foot end of

infant

car seat/

carrier will rest on

the two L-shaped

brackets.

Cosco, Eddie Bauer,

Evenflo, Discovery, Peg-Perego

Use object to press in plastic tabs to release right and left end caps.

(See diagram A)

The plastic tabs are located underneath the front rail

of the stroller on the plastic right and left rail covers.

(See diagram 1)

Right and left end caps will be released by pressing in plastic tabs.

(See diagram B)

End caps must be removed to install Cosco Eddie

Bauer, Evenflo, Discovery or Peg-Perego

infant carrier.

Bauer, Evenflo, Discovery or Peg-Perego

WARNING

Never

use this product without securing the

attachment

strap to the infant seat.

WARNING

The infant harness must be buckled correctly per your

manufacturer's instructions.

Note: Illustrations are

for

reference only and may not

represent the

actual product.

Remove End Cap

REMOVING THE

INFANT SEAT/CARRIER

Remove the infant car seat/carrier by reversing the

above steps.

See your infant car

seat manufactu

rer's

instruction

s for proper rel

ease lever operation.

Bring the infant seat attachment straps through the

seat belt guides in the infant car seat/carrier and fas-

ten the buckle. To loosen,

tilt the buckle and pull up.

To tighen, pull the strap.

WARNING

Make sure

you tighten the attachment strap before

ge.