Installation Instructions
9
WM2XXSI/WM2XXAUSI Placement and
Projection Area Constraints (See Figure 3)
• There should be a minimum distance of 12 inches
between the base of the dual mount and the top of the
projection image.
• The distance between the base of the dual mount and
the bottom corner of the projection image (both right
and left) should be less than or equal to 110 inches.
• The projection image should start a minimum of 1 inch
from the base of the top frame of the whiteboard.
• The projection image should be positioned within the
fan area extending from the Chief Interactive Dual
Mount. This fan area should not exceed 140 degrees.
Whiteboard Constraints
• The whiteboard should not be thicker than 1". (See
Figure 3)
• The ledge of the whiteboard frame should be less than
or equal to 1/3". (See Figure 3)
Important Notes
• Do not put sticky notes, hanging paper, cables, outlets,
or other items below the wall mount or inside the
capture area. (See Figure 3)
• Image should be placed one inch below the edge of the
whiteboard to minimize interference from the frame top.
Figure 3
140°
>1"
<1"
<
1/3"
<
110 inches
<
110 inches
Minimum 12 inches
from base of mount
to projection
Projection
(Whiteboard side view)
Whiteboard
ledge
Capture area
Projected areas
