PAC115-116-117 Installation Instructions
4
INSTALLATION
WARNING: USING THIS PRODUCT INCORRECTLY
MAY RESULT IN SERIOUS PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! Do NOT use the PAC115-116-
117 to fasten a mount into only drywall!
1. Drill a 1/2" hole at the desired location.
2. Hold metal channel on anchor (A) flat alongside plastic
straps and slide channel through hole. (See Figure 1)
Figure 1
3. Holding plastic straps on anchor (A), pull anchor away from
wall until channel rests flush behind wall making sure anchor
channel is positioned vertically on stud. (See Figure 2)
4. Slide plastic cap on anchor (A) towards wall until flange of
cap is flush with wall. (See Figure 2)
Figure 2
5. Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 3)
6. Repeat Steps 1 through 5 for each mounting hole.
Figure 3
7. Place mount over anchors and align mounting holes in
display mount with holes in anchors. (See Figure 4)
WARNING: IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Overtightening of
mounting hardware can damage the steel studs. DO NOT
overtighten mounting hardware!
8. Insert 1/4-20 x 1-3/4" Phillips pan head screw (B) through
1/4" washer (C), corresponding mounting hole on mount
and into anchor (A) and tighten until flush against mount.
DO NOT overtighten! (See Figure 4)
9. Repeat Steps 7 and 8 for remaining mounting holes.
Figure 4
(A)
Drywall
Plastic Straps
2
(A)
Plastic Cap
Drywall
Anchor Metal Channel
SIDE VIEW
3
Steel Stud
4
Plastic Straps
Drywall
Anchor Metal Channel
Plastic Cap
SIDE VIEW
5
Steel Stud
Drywall
Anchor Metal Channel
Mount
SIDE VIEW
(B)
8
Steel Stud
(C)
