Installation Instructions K4G120
11
Pitch
1. Loosen knob on side of center faceplate assembly. (See
Figure 17)
2. Adjust pitch as desired. (See Figure 17)
3. Tighten knob to secure desired pitch position. (See Figure
17)
Figure 17
Roll
1. Loosen screws holding display to faceplate slightly.
2. Adjust roll position as the mounting holes on faceplate
allow.
3. Tighten screws to lock roll position.
Cable Management - Clips
1. Use two #10-24 x 3/8” button head cap screws (E2) to
attach two tie mounts (E1) to upper mounting arm. (See
Figure 18)
2. Use two #10-24 x 3/8” button head cap screws (E2) to
attach two tie mounts (E1) to lower mounting arm. (See
Figure 18)
Figure 18
3. Route cables along mounting arms. (See Figure 19)
4. Use cable ties (not included) to secure cables to tie clips
(E1). (See Figure 19)
NOTE: Leave enough slack in the cables so that arm may still
swing without resistance from the cables.
Figure 19
5. Route cables through cable management cover (Y). (See
Figure 20)
6. Attach cable management cover (Y) to back of column.
(See Figure 20)
Figure 20
1
3
2
(E2) x 2
1
(E1) x 2
(E2) x 2
2
(E1) x 2
cable
(example)
cable ties (not included)
4
5
6
(Y)
