A SERVICE OF

logo

Open as PDF
next previous
Installation Instructions FCA105
5
Assembly And Installation
Installing FCA105 Wall Plate to XTM/XSM Mount
1. Remove caps from one side of mounting rails on XTM/XSM
mount. (See Figure 1)
Figure 1
2. Slide FCA wall plate (A) onto XTM/XSM mount rails. (See
Figure 2)
3. Reinstall caps onto mounting rails. (See Figure 2)
Figure 2
4. Position three wall plates 16" apart from each other on rails.
(See Figure 2)
Figure 3
Installing to a Wood Stud Wall
1. Determine the center of the display, and where it should be
located on the wall.
2. Locate the appropriate three 16" studs at the selected
location.
3. Line up the notches on mount with center of screen marking
to determine vertical center. (See Figure 4)
4. Measure up 7-1/2" (190.5mm) from the center point to mark
location of the upper mounting slots.
Figure 4
1
3
2
2
2
16"
16"
Center of screen
7-1/2"
Vertical center
of mount
(190.5mm)