COLORstrip™ Mini User Manual 13 1/26/2010 2:49 PM
DMX Control Mode
Operating in a DMX Control mode environment gives the user the greatest flexibility, when it comes
to customizing or creating a show. In this mode, you will be able to control each individual trait of the
fixture and each fixture independently.
Daisy Chain Connection
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the first
fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connector to the
input connector of the next fixture consisting of a (male) 3 pin connector. Then, proceed to connect from
the output, as stated above, to the input of the following fixture and so on.
DMX mode setup
1. Press the Mode button, until the display reads [SYS]; then, press Enter.
2. Press the Up/Down buttons until the display reads [S dAd]; then press Enter.
3. Set the DMX address value by using the Up/Down buttons. Press Enter.
4. Press the Mode button.
You can use the
Master/Slave link to
control multiple units as
one DMX device. Read the
instructions on the
following page.
