37
Returning to a Pre-marked Position
If you wish to return to a particular
scene later, mark the point with the zero
set memory and the tape will stop at
that point when you rewind/fast forward
the tape.
This function is operated with
the wireless controller.
1 While recording or during
playback, press
at the point you wish to return to
later.
• The time code changes to
“0:00:00 ”.
• Press again to
cancel the memory.
2 If you marked the zero memory
while recording, set the
camcorder to mode. If
you marked the zero memory
during playback, press .
3 Press to locate the zero mark.
• If the tape counter shows a
negative number, press
instead.
• appears and the camcorder
rewinds/fast forwards the tape.
• The tape stops at or near the zero
mark, disappears and the
correct time code will be displayed
again.
Special Playback Modes
1
To enter most special playback modes you need to operate the buttons on the
wireless controller ( 15). There is no sound during the special playback modes.
1
During some special playback modes you may notice some anomalies (blocky video
artifacts, banding, etc.) in the playback picture.
Special playback mode Initial mode
Operation on the camcorder
or on the wireless controller
Fast playback Normal playback : Push the joystick ( ) toward or
( ) toward and hold it down.
: Press and hold or
Reverse playback Normal playback : Press
1 frame reverse/advance Playback pause : Press or
Frame-by-frame playback Playback pause : Press and hold or
Slow playback Normal or reverse
playback
: Press
Double speed playback Normal or reverse
playback
: Press
Return to normal playback Special playback mode : Push the joystick ( ) toward / .
: Press
REW FF
SLOW
PLAY
( 23)
ZERO SET MEMORY
ZERO SET MEMORY
STOP
COPY
