A SERVICE OF

logo

58
Chapter 6 Maintenance
3
Spin the rollers while wiping them clean with a firmly wrung cloth
dampened with water or a mild detergent.
There are 14 roller positions, as shown in the diagram below.
Use cotton swabs to clean the rollers in locations that are too narrow for your
fingers.
Rollers in positions o to !3 are turned by the roller in position !4. Turn the roller
in position !4 to wipe the rollers.
Open the scanning unit to clean the rollers in positions u to !2.
4
Push down the lock lever to release the lock on the scanning unit
(q), and then open the scanning unit (w).
5
Use cotton swabs that are commercially available to clean the
entire scanning glass.
Scanning Unit
Note
Scanning Glass
(two sides)
Lock Lever