Suspended Ceiling Mount Backbox Modules | Instruction Manual | Advanced Commands
Bosch Security Systems | 10 December 2003
EN
|
15
6 BASICDOME ADVANCED COMMANDS
To use Locked Commands, you must first unlock the BasicDome via OFF-90-ENTER.
All locked settings, except FastAddress, can then be changed via ON-46-ENTER.
Disallow these commands via ON-90-ENTER.
SETUP
Commands
FastAddress
Display FastAddress
Auto Iris
Auto Focus
Gain Control
On-screen Display
On-screen Display Adjust
Sector Title Edit
Sector Blanking
Bypass All Blanking
Lock/Unlock Commands
Password
Factory Home Position
Restore Defaults
Left Limit
Right Limit
Inactivity
Preset Tour Period
AutoPivot
Select White Balance
Sharpness
Iris Adjust
Sync Mode
Adjust Line Lock Phase
Switch Polarity
Keystrokes
ON-999-ENTER
ON-998-ENTER
ON-997-ENTER
ON/OFF-3-ENTER
ON/OFF-4-ENTER
ON/OFF-43-ENTER
ON/OFF-60-ENTER
ON/OFF-61-ENTER
ON/OFF-63-ENTER
ON-86-ENTER
OFF-86-ENTER
ON/OFF-90-ENTER
SET-802-ENTER
SET-110-ENTER
ON-40-ENTER
SET-101-ENTER
SET-102-ENTER
ON/OFF-9-ENTER
ON/OFF-15-ENTER
ON/OFF-18-ENTER
ON/OFF-30-ENTER or
ON/OFF-35-ENTER
ON/OFF-44-ENTER
ON/OFF-11-ENTER
ON/OFF-42-ENTER
ON/OFF-41-ENTER
ON-91-ENTER
Description
Sets/changes the dome address using the keyboard and on-screen menus. (for cameras not
already configured).
Sets/changes the dome address using the keyboard and on-screen menus. (for all cameras,
even those already configured).
Briefly displays all dome addresses.
Camera (iris) adjusts automatically/manually (On/Off) to light conditions.
Camera automatically/manually (On/Off) focuses.
Turns gain control to Automatic or Off. When in Automatic mode, the gain increases to
compensate for darker scenes.
Turns On/Off the On-screen Display. When off, there is no On-screen feedback.
Changes the characters and position of the display. On-screen instructions are provided.
Edits the current Sector name. On-screen instructions are provided.
Masks video from being displayed in selected sectors.
Removes all viewing restrictions imposed by sector blanking but keeps their locations in memory.
ON-86-ENTER reactivates all blanking.
Allows/Disallows Locked Commands to be accessed.
Sets or displays password. See AutoDome Security, SECTION 4 for details.
SET recalibrates camera and returns it to home position.
Restores Factory Defaults.
Sets the current position as the left limit of Auto Pan. Default is 0 degrees.
Sets the current position as the right limit of Auto Pan. Default is 359.9 degrees.
Selects the mode that the dome reverts to after a duration without operator activity.
Default is OFF.
Increase/Decrease (On/Off) the time between Presets during Preset Tour.
Allows a subject to be followed while beneath the camera, without inverting the picture.
Default is ON.
Adjusts camera color (white balance) for specific settings.
Picture (vertical aperture) sharpens/softens.
Edits the Auto Iris level.
Sets camera sync for external-line/internal-crystal (On/Off).
Changes the phase delay of the camera when in external line lock mode.
Switches the polarity of the Zoom, Focus, and Iris controls.
GENERAL
PTZCAMERA
