SAFETY AND HEALTH CONSIDERATIONS
Before opening tank be sure that it is not pressurized. Be sure that the gauge reads ”0 PSI”.
Depressurize the tank before opening it by exhausting pressure through the sanding gun
(#24).
Disconnect the air compressor before opening tank.
Protect yourself and those around you from “overspray”. Remember that your portable
sandblaster is shooting a powerful spray of abrasive material. Do not point it at yourself or
anyone around you.
Wear a filter or mask over your mouth when using this unit. You will create a cloud of
abrasive material and debris which is dangerous to inhale.
Remove cover or protect anything around you that might be damaged from direct or indirect
contact with the abrasive spray or particles. Anything subject to contamination damage
(computers, electronics, etc) or anything with a fine surface (automobiles, furniture, etc.)
should NOT be near your sandblaster.
CAUTION:
1. Pay particular attention to the sand hose (#21), sanding gun (#24) as they will wear out
much more quickly than others pieces.
2. The sand hose needs replacing when its side walls develop leaks or show blisters in the
surface. Do not use if any of these problem are present.
SPECIFICATION:
Model: ATD-8401
Tank Volume: 5 Gallon
Hose Length: 8 Feet
Working Pressure 60-125PSI
Air Consumption: 6-25CFM
Overall Dimensions: L:18.89” x W: 11.42” x H:32.68”
Weight: 27lbs
