A SERVICE OF

logo

Open as PDF
next previous
4
ADJUSTMENT
1. Fine-tune the gun to your desired working settings of spray patters, fluid
output and degree of paint atomization using the three controls illustrated in
Figure 5.
Figure 5
Maintenance
To clean the gun, pour any leftover paint back into its container. Using thinner,
clean out the paint cup and cap. Spray some thinner through the gun to clean the
spray head, needle and nozzle. Spray until thinner comes out clean. Clean all paint
passages as any paint left in the gun and allowed to dry can clog the spray head.
Wipe the exterior of the gun with the cleaning brush included and a soft cloth
moistened with thinner. If you remove the needle, remove the nozzle as well to
protect the seat. NEVER DIG WITH A WIRE OR HARD OBJECT AS THIS CAN
DAMAGE THE NEEDLE SEAT. Remove all such paint before it has a chance to
dry.