REPLACING FRONT OR REAR COVER LENS.
z When the front or rear cover lens becomes damaged
(cracked, scratched, stained or pitted) you must replace
it. Place your finger or thumb into the recess at the
bottom edge of the window and flex the window
upwards until it releases from one edge. (Replacement
of front cover lens is shown below in fig.4)
CHANGING THE SHADE CARTRIDGE
. (See figs.5a & 5b)
FITTING NEW CARTRIDGE.
z Take the new shade cartridge and pass the potentiometer cable under the plastic retainer
before dropping the cartridge into its retaining frame inside the helmet. Cover the plastic
retainer and ensure that the screws are properly close as shown in fig.5b.
z CLEANING: Clean helmet by wiping with a soft cloth. Clean cartridge surfaces regularly.
Do not use strong cleaning solutions. Clean sensors and solar cells with denatured alcohol
and a clean cloth and wipe dry with a lint-free cloth.
Viewing Area: 100 x 60 mm
Size of Cartridge: 114 x 133 x10 mm
UV/IR Protection: Up To Shade DIN16 at all times.
Light State: DIN 4
Variable Shade: DIN 9 to 13
Power Supply: Solar cells, Battery included
Power On/Off: Fully Automatic
Sensitivity: Adjustable
Switching Time: 1/25000 sec. From light to dark
Delay time: 0.2 ~ 0.8s
MAINTENANCE
TECHNICAL SPECIFICATIONS
