Assembly Instructions:
1. Press the buon on the base
2. Insert the fan into the bracket until the buon pops-up from the hole
Operang Instrucons:
1. Place the fan on a safe, flat surface where it cannot fall or be pulled by the cord.
2. Select desired direcon of air flow by lng the fan grill upward or downward.
3. Plug unit into electrical outlet.
4. Select preferred speed (1-Low, 2-Med., 3-High) by rotang the switch on the back of the unit.
5. Always turn off (0-Off) and unplug fan aer using.
Servicing Instrucons:
1. Unplug the fan by griping the plug directly.
2. Open fuse cover.
3. Select a suitable tool, small flat screwdriver or similar tool, and insert the p of the tool into the gap of the plug face.
4. Press the tool down, then pry the protecon door of the fuse out unl the fuse is fully accessible.
5. Carefully remove the fuse.
6. To avoid risk of fire, make sure replacement fuse is a 5 AMP 125 VOLT fuse.
7. Place the new fuse in the slot and carefully press down by pushing gently on the copper caps on either side. Be careful
not to push too hard to avoid damage to the fuse.
8. Close fuse cover. Push the protecon door back into place. If the door will not go back into original place, ensure that
the fuse is properly situated. Be careful not to force the door as this could damage the fuse or the door.
1
2
3 4
5
6 7
