EKI-2525P_Manual_ed1 8
Chapter 2 Installation
In this chapter, you will be given an overview of the EKI-2525P hardware installation
procedures.
2.1 LED Indicators
There are few LEDs display the power status and network status located on the front
panel of EKI-2525P, each of them has its own specific meaning as the table below.
Table 2.1: EKI-2525P LED Definition
LED Color Description
On Power input 1 is active
P1 Green
Off Power input 1 is inactive
On Power input 2 is active
P2 Green
Off Power input 2 is inactive
On Power input 1 or 2 is inactive
P-Fail Red
Off Power input 1 and 2 are both active, or no power input
On
A device is connected utilizing Power over Ethernet on the
corresponding port
FWD (1 ~ 4) Green
Off No device attached or power over Ethernet function failed
On Connected to network
Flashing Networking is active
Link/Active
(1~5)
Green
Off Not connected to network
On Ethernet port full duplex
Flashing Collision of packets occurs
Duplex/Collision
(1~5)
Yellow
Off Ethernet port half duplex or not connect to network
