Filter
Top Products
• Delay start, a time value indicated in hours and
selected by means of the relevant button (max 23
hours).
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the “Start/Pause” button, the
countdown begins, and the delay time value decreases
by one unit every hour and then, when remain the last
2 hours each 30 min.
You can delay the start of the selected programme by
up to 23 hours in one hour intervals.
• An incorrect option selection has been made: this is
indicated by the message Err when a function
incompatible with the current programme is selected.
The incorrect selection is also indicated by an audible
warning signal.
• An alarm code indicates a fault in the machine
operation (see the relevant chapter on page 20).
E20
8
•
Duration of washing programme in hours and
minutes, after you have selected a programme.
While the programme is running (after you have
pressed the “Start/Pause” button), the displayed time
value decreases by one unit every minute.
• The washing machine has stopped with water in the
tub, at the end of a programme with the “Night cycle”
option: this is indicated by a flashing zero.
• The washing machine has completed the
programme: this is indicated by a flashing zero. At
the same time, the door locked light goes out.
The zero will reappear when you switch the washing
machine on, unless the previous programme has been
erased by means of the “Skip Reset” button.
Important!
The first time you use the washing machine, when
you switch it on, it may display a flashing zero and give
an audible warning signal. This is due to the fact that the
washing machine has performed a washing cycle during
the manufacturer’s inspection tests, and this cycle has
not been erased after its completion.
0
2.05
---
132983440.qxd 18/10/2005 10:11 Pagina 8